Nevion FSR-HD Manuel d'utilisateur

Nevion

FRS-HD Rev. G nevion.com | 10 that the incoming video is iso-synchronous, but that it lags 20 lines after the sync. We will then have the sit

FRS-HD Rev. G nevion.com | 11 Figure 7: Another example of delayed outgoing video To reiterate: The phase delay can be both positive and neg

FRS-HD Rev. G nevion.com | 12 For a scenario where the card receives different HD video standards, (e.g. 1080i25 and 720p50) the user may

FRS-HD Rev. G nevion.com | 13 If sync input disappears Given that stable SDI input and sync input exists: If the sync signal disappears, the

FRS-HD Rev. G nevion.com | 14 3.7 Video processing block The video processing block consists of a gain and offset adjustment, and a video pay

FRS-HD Rev. G nevion.com | 15 3.11 Audio de-embedder The Audio de-embedder extracts all audio embedded in the video stream. The d

FRS-HD Rev. G nevion.com | 16 3.15 Audio processing block The output of each stereo signal from the audio cross point matrix may be manipulat

FRS-HD Rev. G nevion.com | 17 4 Configuration The board can be configured both manually and through the Nevion control system GYDA.

FRS-HD Rev. G nevion.com | 18 Switch # Function name Function DIPs Comment 6 AES channel Off = ch1, On = ch2 (of group selected from DIP4&am

FRS-HD Rev. G nevion.com | 19 Switch # Function name Function DIPs Comment 16 OVR Off: GYDA mode On: Manual mode This DIP is only read at pow

FRS-HD Rev. G nevion.com | 2 Nevion Support Nevion Europe P.O. Box 1020 3204 Sandefjord, Norway Support phone 1: +47 33 48 99 97 Support pho

FRS-HD Rev. G nevion.com | 20 4.2 GYDA mode All functions of the card can be controlled through the GYDA control system. The GYDA has an info

FRS-HD Rev. G nevion.com | 21 4.2.2 Configuration page The different configuration possibilities are explained in detail in Chapter 3, under

FRS-HD Rev. G nevion.com | 22 Figure 12: Configuration page (3 screen dumps at different positions on the page)

FRS-HD Rev. G nevion.com | 23 5 Connections Figure 13: FRS-HD-DMUX-C1 (this is rev.2 of the backplane) The backplane for the FRS-HD-DMUX is

FRS-HD Rev. G nevion.com | 24 6 Operation 6.1 Front panel LED indicators Diode \ state Red LED Orange LED Green LED No light Card status PTC

FRS-HD Rev. G nevion.com | 25 6.4 RS422 commands 6.4.1 FLP4.0 required commands Block Blk# Commands Example Response Control - - ? ? product

FRS-HD Rev. G nevion.com | 26 control. Note 1: The info part of misc has additional functionality when locate is used: locating <remaining

FRS-HD Rev. G nevion.com | 27 we're in generator mode (lost both physical inputs) and both physical inputs reappear at more or less the

FRS-HD Rev. G nevion.com | 28 input signal left untouched) 1: Embedding on rcl 0 - rcl 0 lock | lol Reclocker. No control; only used to repor

FRS-HD Rev. G nevion.com | 29 green | magenta | red | blue | black flat <Y> <Cb> <Cr> video <lns>/<rate><

FRS-HD Rev. G nevion.com | 3 Contents 1 Product overview ...

FRS-HD Rev. G nevion.com | 30 Note 2: The resolution of the lvl control is 0.5dB but the card will perform correct rounding to nearest legal

FRS-HD Rev. G nevion.com | 31 General environmental requirements for Nevion equipment 1. The equipment will meet the guaranteed performance s

FRS-HD Rev. G nevion.com | 32 Product Warranty The warranty terms and conditions for the product(s) covered by this manual follow the General

FRS-HD Rev. G nevion.com | 33 Appendix A Materials declaration and recycling information A.1 Materials declaration For product sold into Chin

FRS-HD Rev. G nevion.com | 4 1 Product overview Figure 1: Simplified block diagram of the FRS-HD-DMUX card The Flashlink FRS-HD-DMUX synchro

FRS-HD Rev. G nevion.com | 5 2 Specifications Optical SDI input Data rate optical: 270 – 1485 Mbps Sensitivity - HD-SDI (1485 Mbps): Better

FRS-HD Rev. G nevion.com | 6 Analog Audio output Number of outputs 1 stereo pair Connectors 2 x WECO audio connectors Impedance < 66R Dyn

FRS-HD Rev. G nevion.com | 7 3 Description 3.1 Data path HD/SD-SDI input is selected from either optical or electrical input and equalized, r

FRS-HD Rev. G nevion.com | 8 3.3 Optical/ Electrical input selection The FRS-HD-DMUX has both an optical (option, see Chapter 1.1) and an ele

FRS-HD Rev. G nevion.com | 9 outgoing video and the sync signal. The parameter really determines a delay on an internal sync signal, is